Vonnic Standalone DVR User Manual download pdf (Page 138)

129

Figure 7-46

Please refer to the following sheet for detailed information.

Parameter

Function

Enable

You need to check the box to enable this function.

Please select a channel from the dropdown list.

Period

This function becomes activated in the specified periods.

There are six periods in one day. Please draw a circle to

enable corresponding period.

Select date. If you do not select, current setup applies to

today only. You can select all week column to apply to the

whole week.

Click OK button, system goes back to local alarm

interface, please click save button to exit.

Anti-dither

System only memorizes one event during the anti-dither

period. The value ranges from 5s to 600s.

Sensor type

There are two options: NO/NC.

Record channel

System auto activates motion detection channel(s) to

record once an alarm occurs. Please note you need to set

alarm record period and go to Storage-> Schedule to set

current channel as schedule record.

Record Delay

System can delay the record for specified time after alarm

ended. The value ranges from 10s to 300s.

Alarm out

Enable alarm activation function. You need to select alarm

output port so that system can activate corresponding

alarm device when an alarm occurs.

Latch

System can delay the alarm output for specified time after

an alarm ended. The value ranges from 1s to 300s.

Show message

System can pop up a message to alarm you in the local

host screen if you enabled this function.

Buzzer

Check the box here to enable this function. The buzzer

beeps when an alarm occurs.

Alarm upload

System can upload the alarm signal to the centre

(Including alarm centre.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 186 187

Comments to this Manuals

No comments

Vonnic Standalone DVR User Manual Page 138

Comments to this Manuals

Related products and manuals for Video surveillance kits Vonnic Standalone DVR